A collection of motorcycle tools. Most of these tools are available but I often design and print my own. The STL files are hosted on thingiverse.


This damper rod holder tool is for holding 12.5, 14, 16 and 18mm KYB and Showa cartridge and shock shaft rods. The rods use chrome, DLC, Kashima and other sensitive coatings that may scratch from metal holders. I recommend 100% infill for clamping force.




This cartridge jam fork tool is for holding 12.5 and 14mm KYB and Showa spring fork cartridge rods for base nut removal. The rods use chrome, DLC, Kashima and other sensitive coatings that may scratch from metal holders. I recommend 100% infill for clamping force.




KYB/Showa 50mm shock seal body driver for KYB and Showa 50mm bodies. 100% infill is recommended.




The Bell Moto 9 Flex helmet mouthpiece clips break forcing you to buy the whole mouthpiece. These are the replaceable clips that are held in place with a small Phillips screw.




The Motion Pro fork oil leveling tool syringe does not put enough pressure on the rubber sealing head. It tends to pop off during use. This syringe is 2mm larger at the sealing head mounting area.




Wheel plugs for 25mm and 22mm axles used for washing wheels.




This chain block measuring tool is used to produce a consistent chain slack measurement. It sits up against the swingarm chain guide. It is 58mm talls and allows for an extra 3mm of slack for sand and silt build up in the chain that causes premature wear and potential chain breakage.




This shock shaft protector is for KYB and Showa 16 mm shock shafts. It protects the Race Tech spring compressor tool from making direct contact with the coated shock shaft.




This shock shaft protector is for KYB and Showa 18 mm shock shafts. It protects the Race Tech spring compressor tool from making direct contact with the coated shock shaft.




This cartridge holder tool is for holding 28mm KYB and Showa inner chamber cartridges when disassembling them. 100% infill is recommended for clamping force.




This cartridge holder tool is for holding 29mm KYB and Showa inner chamber cartridges when disassembling them. 100% infill is recommended for clamping force.




This cartridge holder tool is for holding the 34mm Showa SSF TAC inner chamber cartridge when disassembling. 100% infill is recommended for clamping force.




This 7 mm tipped valve punch tool is used to seat the 4-5mm valves after installing the keepers. This size can be found on most 250f’s.



This 9 mm tipped valve punch tool is used to seat the 5.5mm valves after installing the keepers. This size can be found on most 450f’s.



More coming soon.